Link ECU - Ballast Resistors Please choose your resistor quantity:Set of 4 x 4.7ohm 25w resistors mounted to a heatsink.

Link ECU - Ballast Resistors Please choose your resistor quantity:Set of 4 x 4.7ohm 25w resistors mounted to a heatsink.For use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Choose between a set of 6 4 2 or a single x 4. 7ohm 25w resistor mounted to a heatsink. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the chassis.

Quick and easy installation of the Haltech iC-7 dash into a Non-EFI Vehicle

these are generally made to order and carry an estimated wait time of 3-6 weeks

These come in a standard PRP Purple or black

PCLink Logging:

Subaru (both STI and 5speed)

R34 vehicles will need 20mm modification of both driveshafts but revised kit will be available soon

Please see the HP guide below to better assist you in choosing the correct fuel pump for your application:

these knuckles will only work with the use of either OEM S/R outer tie rod ends

The wiring pinout for this sensor is marked directly on the sensor

The OEM clutch damper delete clutch line that runs from the master cylinder to the slave cylinder measures 50cm end to end

The GReddy Magnetic Oil Drain Plug is a powerful 5000 gauss neodymium magnet

2 to 4 Rotor engines