Hornady Cam Lock™ Bullet Puller for Reloading Presses brand_-NANUK

Hornady Cam Lock™ Bullet Puller for Reloading Presses brand_-NANUKThe Hornady Cam Lock Bullet Puller (Item #050095) is a press mounted tool designed to disassemble loaded rifle cartridges quickly and without damage. Where a kinetic (hammer style) puller can mark or deform projectiles, the Cam Lock clamps directly onto the bullet using a calibre specific collet, then a single downward stroke of the press handle draws the bullet cleanly from the case. Both the bullet and brass are preserved in usable condition, and

Napier's Protector 1 Double Detachable Rifle Slip is the answer for anyone who regularly carries two rifles to the same shoot

Front Lens Size: Up to 45mm - This figure describes the maximum size of the objective (front) lens the mount is designed for when the dovetails are flush with the barrel

and the quick-release action means swapping optics takes moments rather than minutes

Simple controls allow for easy changes of units or tare weights

whenever you only need to carry one gun

designed to be handheld or mounted on a gun scope or mono-pod via its integrated Picatinny rail

Unique to the 7C

so the rifle can be levelled without breaking the shooting position

with a seat height of 48 to 50cm that keeps you off cold ground for hours of observation

Once dry it is fully compatible with supplementary finishing oils

which translates directly into tighter groups at the target

ergonomic design and industry leading SUB 20mK NETD thermal sensor that delivers the ultimate image detail